镜面辊筒的清洗方式，靠前个方面来讲也就是会采用手工清洗方法，把清洗剂涂覆于工件的表面，对于镀铬金属工件来讲的话，我们在很大的程度上也就是会应用在铜丝刷子进行清洗；且就陶瓷辊筒则必须是要注意用钢丝刷子进行清洗。油缸电镀修理

就镜面辊筒上述清洗方法本身也就是会比较方便，这样一来，就其在很大的程度上也就是不会产生什么污染现象，但当其清洗的不彻底的时候，就其在很大的程度上也就是会影响到其本身的传墨效果。一般来讲，就它本身也就是会适用在低网线的镜面辊筒或者是不是很脏的镜面辊筒。

紧接着，对于镜面辊筒也就是会采用化学清洗方法，把腐蚀性清洗剂均匀的就涂抹在了超镜面辊筒表面，必要的时候，在工件表面上直接的就包裹了一层塑料制品以防**液挥发，把镜面辊烧蚀1～48小时，等到固化的油墨充分进行软化之后，再用水或者是酒精**液结合手工清洗法对于镜面辊进行清洗


The first aspect of the cleaning method of the mirror roller is to use the manual cleaning method to coat the cleaning agent on the surface of the workpiece. For chrome-plated metal workpiece, we will apply it to a large extent. Brush cleaning; And on the ceramic roller must be paid attention to the use of steel wire brushes for cleaning. Cylinder plating repair
On the mirror roller, the above cleaning method itself will be more convenient, so that to a large extent it will not cause any pollution, but when the cleaning is not complete, To a large extent, it will affect its own ink transmission effect. In general, it itself is a mirror roller that will apply to low mesh lines or is not a dirty mirror roller.
Then, for the mirror roller, which will use chemical cleaning methods, the corrosive cleaning agent is evenly applied to the surface of the supermirror roller. When necessary, a layer of plastic is directly wrapped on the surface of the workpiece to prevent * * liquid volatilization. The mirror roller is ablated for 1 to 48 hours. After the cured ink is fully softened, the mirror roller is cleaned with water or alcohol ** solution combined with manual cleaning.